Resin&Mold

A working handbook for resin art and casting at home

The process

  1. Choose your resin
  2. Workspace and safety
  3. Molds and release
  4. 1Measure and mix
  5. 2Color and add-ins
  6. 3Pour and pop bubbles
  7. 4Cure and check
  8. 5Demold and finish

Reference

  • Fix a problem
  • Charts
  • Resin calculator
  • Mixing ratio calculator
  • Gear guides
  • All notes

Gear links go to Amazon. As an Amazon Associate I earn from qualifying purchases.

Resin&Mold
MenuClose

The process

  1. Choose your resin
  2. Workspace and safety
  3. Molds and release
  4. 1Measure and mix
  5. 2Color and add-ins
  6. 3Pour and pop bubbles
  7. 4Cure and check
  8. 5Demold and finish

Reference

  • Fix a problem
  • Charts
  • Resin calculator
  • Mixing ratio calculator
  • Gear guides
  • All notes
  • Choose your resin
  • Workspace and safety
  • Molds and release
  • 1Measure and mix
  • 2Color and add-ins
  • 3Pour and pop bubbles
  • 4Cure and check
  • 5Demold and finish
Handbook / Fix a problem

Fix a problem

What went wrong, and what to change

Start from what you see. Each note gives the likely causes in order and one change to make on the next try.

  • Resin is cloudy, milky or hazyCloudy epoxy or UV resin has 7 usual causes. Match yours in the table, then fix it: warm bottles 10 to 15 minutes, wash off blush, sand or top coat.Demold and finish→
  • Cured resin is bendy, flexible or rubberyBendy or rubbery resin usually needs more cure time: 2 to 7 more days in a warm room. A fingernail test tells a slow cure from a ratio or mixing fault.Cure and check→
  • UV resin is sticky or tacky after curingUV resin sticky after curing? Match what you see in the table: tacky film, sticky mold side, soft inside or dense color. Fixes with lamp times and limits.Cure and check→
  • Bubbles in epoxy or UV resinGet bubbles out of epoxy and UV resin: a where-are-the-bubbles table, heat gun and toothpick fixes, and prevention up to a 40 to 60 psi pressure pot.Pour and pop bubbles→
  • Epoxy resin is still sticky after curingEpoxy still sticky after 24 to 72 hours? Tell wet, tacky and soft-spot cures apart, find the cause, and see what warmth or a fresh coat can save.Measure and mix→

Resin and Mold

A working handbook for resin art and casting at home. Gear picks are chosen from what the Amazon listings state, not from hands-on tests. How that works.

AboutHow we pick gearContactAffiliate disclosurePrivacy

© 2026 Resin and Mold. As an Amazon Associate I earn from qualifying purchases. Prices and availability are shown as of the time stated and can change.